On 7/22/2015 9:57 PM, venkat kulkarni wrote:
Hello Tom,
Thanks for reply. Can you please provide me full command
for increasing size for SASMMOD1 , as I have never used this utility
before. My current size is
Data Set Name . . . : SYS1.SASMMOD1
General Data Current Allocation
Volume serial . . . : RESALT Allocated blocks . : 29
Device type . . . . : 3390 Allocated extents . : 1
Organization . . . : PO Maximum dir. blocks : 10
Record format . . . : U
Record length . . . : 0
Block size . . . . : 32760 Current Utilization
1st extent blocks . : 29 Used blocks . . . . : 29
Secondary blocks . : 0 Used extents . . . : 1
Used dir. blocks . : 3
Number of members . : 18
On Thu, Jul 23, 2015 at 7:21 AM, Thomas Conley <[email protected]>
wrote:
On 7/22/2015 9:41 PM, venkat kulkarni wrote:
Thanks to all. I checked JOB report more carefully and found that COMPRESS
and RETRY was specified on the APPLY, so SMP/E was able to recover in most
of these cases. If we check the "CAUSER SYSMOD SUMMARY REPORT", only
SASMMOD1 failed after debatching.
An easy option is to enlarge SASMMOD1 using FIXPDS command, but I am not
sure how to use this to increase size of this dataset.
Can anybody suggest, how can we perform this.
Regards
Venkat
FIXPDS ADDCYL(x)
FIXPDS ADDCYL(x) is the command within PDS. If you go to cbttape.org,
download file182 and follow the install instructions, you should be able
to run the command. If you're a member of SHARE, you can grab my PDS -
The Swiss Army Knife of Utilities presentation at share.org, which shows
how to exploit PDS.
Regards,
Tom Conley
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
