Most typically, that wait state is entered when the system has been deliberately shut down by operators.
Re-IPL. Ant. -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Meenakshi, Vinoth - CW Sent: Thursday, 17 September 2015 2:40 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: IPL Shutdown Problem Hi Ant, We couldn't able to access commands from master console or HMC, since the system went onto wait-state. Central processor (CP) 0 is in a nonrestartable stopped state due to a System Control Program (SCP) initiated reset of the I/O interface for partition LPAR4. The disabled wait program status word (PSW) is 000200008000000000000000000040a2. Could you assist how we move forward from here. Thanks Regards, Vinoth M -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Anthony Thompson Sent: Thursday, September 17, 2015 9:48 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: IPL Shutdown Problem ROUTE command not working is a completely separate issue. It won't happen if that LPAR is outside of the sysplex. You'll need a console on that system. Use the HMC if you need to, assuming you have one. Try the F OMVS, STOPPFS=FZS command on a SYS9 console. F BPXOINIT,SHUTDOWN=FORKINIT should bring down both ZFS and OMVS. $PJES2,ABEND if you absolutely have to. Ant. -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Meenakshi, Vinoth - CW Sent: Thursday, 17 September 2015 1:23 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: IPL Shutdown Problem Thanks Ant & Lizette. F OMVS,STOPPFS=ZFS command worked and we were able to bring down ZFS for one systemSYS3 and for other system SYS9 we are facing an issue. OMVS is down and we tried to issue STOPPFS=ZFS command and it's not allowing. RESPONSE=SYS1 IEE618I ROUTE COMMAND REJECTED. SYS9 I think the system is out of sysplex now and still the below STC are running in SYS9. ZFS STC03291 OMVS 15 EXECUTION SYS9 SYS9 SYSLOG STC09890 +MASTER+ 15 EXECUTION SYS9 SYS9 Regards, Vinoth M -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Anthony Thompson Sent: Thursday, September 17, 2015 8:59 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: IPL Shutdown Problem Stop the ZFS address space. It should stop as part of OMVS shut down anyway, but that's probably post-JES2 completion at your site. Issue command F OMVS,STOPPFS=ZFS. SYSLOG should close as part of normal JES2 shut down. Under z/OS 2.2, it is not recommended to run ZFS processing in its own address space. Ant. -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Lizette Koehler Sent: Thursday, 17 September 2015 12:53 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: IPL Shutdown Problem The list is not the best place for an urgent issue. But we will try to help. If this is PRODUCTION, Just take a Stand alone dump and IPL. If this is any other system - how long can you be down before you IPL. Normally I do the SA Dump and IPL. I worry about why later. You do not want to spend a lot of time trying to resolve things when you are IPL'ing. Especially if this is a critical system. You may need IBM's assistance in determine your shutdown issue, if you have not used IPCS on a Stand alone dump. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] > On Behalf Of Meenakshi, Vinoth - CW > Sent: Wednesday, September 16, 2015 8:03 PM > To: IBM-MAIN@LISTSERV.UA.EDU > Subject: IPL Shutdown Problem > > Hi All, > > We are having issue with bringing down the JES2,two of the STC are > running and it's not coming down. Even Purge command is not working. > > ZFS STC03291 OMVS 15 EXECUTION SYS9 SYS9 > SYSLOG STC09890 +MASTER+ 15 EXECUTION SYS9 SYS9 > > Even we can't able issue command from other systems. > > RESPONSE=SYS9 IEE707I $DA,X NOT EXECUTED > > Kindly guide us on this. > > Thanks. > Vinoth M ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
