Sonny-
For each of your OSA's, you should have a statement like this, which gives the
route to the network for each of your interfaces, followed by a default route.
ROUTE 192.168.168.0 255.255.255.0 = OSAB1L MTU 1492 REPL ( replaceable is
optional)
ROUTE 192.168.169.0 255.255.255.0 = OSAB2L MTU 1492 REPL( replaceable is
optional)
This will give your system a route for each of your interfaces. The "=" says
it's directly connected.
Replaceable is if you have a routing protocol running on the system, and it can
learn routes dynamically.
Cheryl
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf
Of Sonny Gupta
Sent: Saturday, December 05, 2015 4:29 PM
To: [email protected]
Subject: TCPIP Configuration Help
Hello, I have a small z9 System with two OSA Card. I am able connect to only
the one of the OSA Card without any problems and unable to determine what I
need to do in order to connect both of the OSA Cards at the same time. Each OSA
Card is connected to separate --> Switch ---> Firewall --> ISP Modem. I am able
to connect to both of the cards via ICC without any issues. Below are the
statements that I am using:
DEVICE OSAB1 MPCIPA SECROUTER AUTORESTART
LINK OSAB1L IPAQENET OSAB1
HOME 192.168.168.164 OSAB1L
;
DEVICE OSAB2 MPCIPA SECROUTER AUTORESTART
LINK OSAB2L IPAQENET OSAB2
HOME 192.168.169.68 OSAB2L
;
BEGINRoutes
ROUTE DEFAULT 192.168.168.168 OSAB1L MTU 1492
ROUTE DEFAULT 192.168.169.168 OSAB2L MTU 1492
ENDRoutes
What I have been able to determine is that 2nd Route Default statement is
being ignored. I am able to get to 2nd OSA Card if I move the 2nd Route
Statement in front of the 1st one and then of course, I am unable to get to the
first one. I am not an expert is TCPIP and I have spend considerable amount of
time reviewing the manuals along with searching the net. I will be glad to
provide any required information and thanks in advance for any recommendations.
Regards,
Sonny
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email to
[email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
