It is possible to add all three definitions (APPL, DESTID and CONNECT)
dynamically via the $ADD JES2 command.
You will also need to define the remote site as a NODE to JES2. If you have a
node definition available, you can use the $T command to change the NODE
parameters to your desired values. Then the connection will be between this
remote node and your local node (OWNNODE).
You can also look at the NODE parameters called PRIVATE, PATHMGR and ENDNODE.
Depending upon how you set these, you might NOT even need a connect statement.
The PATHMGR parameter needs to be consistent between the two nodes. I.E. both
set to PATHMGR=NO or both set to PATHMGR=YES.
HTH
Tony
________________________________________
From: IBM Mainframe Discussion List [[email protected]] on behalf of
Gilson Cesar de Oliveira [[email protected]]
Sent: Tuesday, April 11, 2017 7:59 AM
To: [email protected]
Subject: NJE between two different NETIDs
Dear list:
We are planning to establish a NJE connection between two different NETIDs
sites in SNA and reviewing the steps we faced in one point related to the
definition of the NODE.
My initial understanding is that we have to configure (to add) in my JES2
configuration the following statements:
APPL => it is possible to add APPL dynamically through the $ADD APPL command.
DESTID => it is possible to add DESTID dynamically through the $ADD DESTid
command.
CONNECT => it is also possible to add CONNECT dynamically through the $ADD
CONNECT command.
The APPL is also defined in VTAM as CDRSC and this definition is made
dynamically with no restart of any service in z/OS.
In order to add a CONNECT, one of the statements needed is NODE (NODEB).
It is supposed to be defined previously but I could not find any way to define
it dynamically.
Does anyone here have another way to establish this connection without to
restart JES2 to add a new NODE ??
Thanks in advance for any help.
Regards,
Gilson Cesar
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
