On Fri, 19 May 2017 08:19:10 -0700, Lizette Koehler <[email protected]> wrote:
>Here is a best guess. > >If the printer was added with $ADD then a hot start may work > >Otherwise, remove the PRINTER definitions from the INIT Deck and then try a >HOT Start. IF that does not work, then you will need an IPL (WARM) Start on >that LPAR. > >Depending on your level of z/OS and JES2 - this should work. > >The worst case I can think of is you have 3 LPARs in the PLEX, and you will >need to shut down all 3 and IPL one after the PRINTER definition is removed in >JES. > >If you have Q&A with IBM, I would open a Usage question for a more accurate >answer. Lizette, Thank you, a Usage Q&A is certainly in order. I thought I'd tap the experience of the collective first... I'm prepared for an all-member warm-start "just in case", but it would be nice to know ahead of time whether that is truly necessary. These have been in our JES2 parms since long before we had anything to do with these systems, and we had to COLD start when we brought these systems in, so no to $ADD, but I don't know if that diminishes the possibility of a hot-start or single-member warm start being sufficient. Maybe it's just me, but the doc is far from clear on removal. When all is said and done, an RCF is also certainly in order. Thanks, Art Gutowski General Motors, LLC ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
