I'm not sure how I would that, or how to point ERBSCAN to use that dataset.
On Wed, Jun 21, 2017 at 11:26 AM, J R <jayare...@hotmail.com> wrote: > Have you tried preallocating a large SYSPRINT dataset? > > > > > On Jun 21, 2017, at 11:05, Mark Pace <pacemainl...@gmail.com> wrote: > > > > I'm trying to run an ERBSCAN against a really large SMF file. > > > > Please Wait... Copying to temporary VSAM dataset... > > > > Then after a minute. > > > > IEC030I B37-04,IFG0554A,MARPACE,IKJACCNT,SYSPRINT,B420,TMPL05, > > SYS17172.T110243.RA000.MARPACE.R0116499 > > *** > > > > So my impression is that the Temporary dataset was defined to small and > ran > > out of extents. Is there some place where I change the default size of > the > > temporary dataset? > > > > > > > > -- > > The postings on this site are my own and don’t necessarily represent > > Mainline’s positions or opinions > > > > Mark D Pace > > Senior Systems Engineer > > Mainline Information Systems > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN > -- The postings on this site are my own and don’t necessarily represent Mainline’s positions or opinions Mark D Pace Senior Systems Engineer Mainline Information Systems ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN