Output fron SITE JESSOWNER=* command:
>>>SITE JESOWNER=*
200-JESINTERFACELEVEL=1. The value of JESOWNER cannot be modified.
200 SITE command was accepted
I am trying to get the output from a job I submitted via FTP, so the
owner the same as the userid I am using for FTP.
Tony Thigpen
JIm Thomas wrote on 08/20/2017 05:12 AM:
Depending on JESINTERFACELEVEL .. try issuing a 'SITE JESOWNER=*' <- (or
submitter's userid) ..
Jim
________________________________
From: IBM Mainframe Discussion List <[email protected]> on behalf of Paul
Gilmartin <[email protected]>
Sent: Saturday, August 19, 2017 9:36:38 PM
To: [email protected]
Subject: Re: grabbing JES output via FTP
On Sat, 19 Aug 2017 21:34:57 -0400, Tony Thigpen wrote:
I am attempting to use FTP under VM to grab some job output from JES2. I
am getting a strange error that I don't know where to start trying to
resolve it. I also get the same messages when I try to ftp from a local pc.
...
EPRT |1|10.10.50.141|1170|
500 unknown command EPRT
thoughts?
RFC 2428?
-- gil
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
