According to the Knowledge Center link that was given, user(AG54) should be user=(AG54).
Bill On Sat, 9 Jun 2018 07:27:19 +0300, saurabh khandelwal wrote: >Hello, > >Thanks for reply. > >below command doesn't work. After changing > >mvs "send 'AG54LST JOB "mtxt"' user(AG54) now" > >to > >mvs "send 'AG54LST JOB "mtxt"',user(AG54),now" > >I stopped getting any notification as i was getting on any system. > >Is there any other syntax for this command . > > >here mtxt is notthing but a tapped message from syslog , we tried to >capture using netview and we should like to display it to particular tso >user when even triger. > >but instead , it was displaying it to all users. I am unable to find >correct way to isolate this issue. > >On Fri, Jun 8, 2018 at 1:52 PM, Elardus Engelbrecht wrote: > >> saurabh khandelwal wrote: >> >> >000120 parse arg mtxt . mtxt >> >> How long is that mtxt? If it is too long, the rest of the message command >> will be trimmed off. >> >> >> >000500 mvs "send 'AG54LST JOB "mtxt"' user(AG54) now" >> >> Change above to this (replacing two spaces with two commas): >> >> mvs "send 'AG54LST JOB "mtxt"',user(AG54),now" >> >> Look up SEND for specific message receivers in >> >> https://www.ibm.com/support/knowledgecenter/SSLTBW_2.2.0/ >> com.ibm.zos.v2r2.ieag100/s1mess1.htm >> >> >> Disclaimer - I am not a NETVIEW expert anymore... >> >> So, you, not me, need to double check all those ' and " are properly >> balanced. >> ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
