Bill,
Thanks for the tip. The cluster that I was using for the model was the data
component. A massive thanks.
Thanks to all who responded with their suggestions.
On Monday, June 11, 2018, 12:00:50 p.m. EDT, Bill Bishop (TMNA)
<[email protected]> wrote:
It could be because you are modeling after the data component and not the
cluster base.
Try modeling it after DSNDBC, not DSNDBD. DSNDBC is the cluster component name
and DSNDBD is the data component name.
Thanks
Bill Bishop
Consultant, Mainframe Engineer
Mainframe and Scheduling | Infrastructure Technology Services
Toyota Motor North America
[email protected]
Office: (469) 292-5149
Cell: (502) 316-4386
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf
Of esmie moo
Sent: Monday, June 11, 2018 10:06 AM
To: [email protected]
Subject: PROBLEM WITH MODEL PARM
Gentle Readers,
I am encountering an error using the IDCAMS/MODEL parm. I googled the error
message but the explanation is not clear.
IDCAMS SYSTEM SERVICES TIME: 09:36:39
DEFINE CLUSTER -
(NAME(PROD.DSNDBD.DSNMDCDB.DSNPROGB.I0001.A001)-
VOL(PROD13) -
MODEL('PROD.DSNDBD.DSNMDCDB.DSNPROGL.I0001.A001') -
)
IDC3501I MODEL ENTYPE IS NOT CONSISTENT WITH THEOBJECT BEING DEFINED
IDC3003IFUNCTION TERMINATED. CONDITION CODE IS 12
IDC0002IIDCAMS PROCESSING COMPLETE. MAXIMUM CONDITION CODE WAS 12 Can you spot
my mistake?
Thanks.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email to
[email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
