Will your Z110S and Z210M systems run simultaneously in different LPARs? If so, then you do not want to copy the catalog entry. This will cause both systems to try to use the same page dataset on the same volume. In this case you need to define new page datasets for Z210M. See the "DEFINE PAGESPACE" command in your "Access Method Services for Catalogs" manual.
If the two systems will run in the same LPAR (obviously not simultaneously) and you really want to use the same page datasets for both, then you need to determine the names of the datasets in the current system. Look up the "D ASM" command in your "MVS System Commands" manual. Then you can copy the catalog entries to your new master catalog **and** update the PAGE parameter in your new IEASYSxx. > -----Original Message----- > From: IBM Mainframe Discussion List <[email protected]> On > Behalf Of johnnydeep san > Sent: Saturday, September 15, 2018 4:19 AM > To: [email protected] > Subject: Re: how to catalog page dataset to new MCAT > > I used todd's jcl and it ran fine but still getting same issue . > > REPRO INDATASET(CATALOG.Z110S.MASTER) - > 00210004 > OUTDATASET(CATALOG.Z210M.MASTER) - > 00220004 > LEVEL(SYS1.PLPA.PAGE) - > 00221004 > MERGECAT > 00222004 > IDC01460I THE NUMBER OF ENTRIES MERGED WAS 0 > > IDC0001I FUNCTION COMPLETED, HIGHEST CONDITION CODE WAS 0 > > > > Should pagedatast locate in new master catalog(CATALOG.Z210M.MASTER) > volume ? . > I haven't any page datasets in new master catalog volume, it's located in > old master catalog volume . how to make understand this page datasets to > new master catalog ? .guide me. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
