In my environment they are clones of each other.
X is the base zone - what I am going to install
Once I install the TLIBs from my X Zone I make a plan to roll to Y zone as
a stable SMP/e environment to roll out
Y is a copy/clone of my X zone, so I am rolling it out to my LPARs/PLEXes
Once I install into a production zone, I plan to roll this up to my Z
zone.
Z is what is in production or a clone of my Y zone.
Lizette
> -----Original Message-----
> From: IBM Mainframe Discussion List <[email protected]> On Behalf Of
> Seymour J Metz
> Sent: Monday, October 07, 2019 11:04 AM
> To: [email protected]
> Subject: Re: SMPe CSI maintenance levels
>
> What are x,y and z, e.g., do they have the same SREL?
>
>
> --
> Shmuel (Seymour J.) Metz
> http://mason.gmu.edu/~smetz3
>
>
> ________________________________________
> From: IBM Mainframe Discussion List <[email protected]> on behalf of
> Bill Giannelli <[email protected]>
> Sent: Monday, October 7, 2019 11:29 AM
> To: [email protected]
> Subject: Re: SMPe CSI maintenance levels
>
> I apologize if this is a dumb question, I have 3 zones, global, target and
> dlib, so if I had an "x y and z" as in your example, would I then have 9
> zones? x global target dlib, y global target dlib, z gobal target dlib?
> thanks
> Bill
>
> ----------------------------------------------------------------------
> For IBM-MAIN subscribe / signoff / archive access instructions, send email to
> [email protected] with the message: INFO IBM-MAIN
>
> ----------------------------------------------------------------------
> For IBM-MAIN subscribe / signoff / archive access instructions, send email to
> [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
