As Bill says. With the caveat that you are using suffix '00' on parms. You will see the BPX mount parm referenced at IPL with the corresponding file system mounts. Check for errors after IPL too (file not found etc.).
On Fri, Oct 25, 2019 at 6:18 AM Bill Johnson < [email protected]> wrote: > BPXPRM00 in parmlib usually. > > > Sent from Yahoo Mail for iPhone > > > On Thursday, October 24, 2019, 3:16 PM, Charles Mills <[email protected]> > wrote: > > Sorry – I know this is an incredibly naïve question. > > I got my VSAM LDS defined and successfully mounted as a zFS path. > > Imagine my surprise when the mount went away at IPL. > > Where do I put a MOUNT statement such that the LDS will get mounted again > at > each IPL? I searched KC, Init and Tuning, and SYS1.PARMLIB for 'MOUNT' with > no relevant hits. > > Or is there a way to make the mount itself "permanent" such that it > survives > an IPL? > > Thanks for your patience. > > Charles > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > -- Wayne V. Bickerdike ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
