Perhaps part of the service procedure in the program directory will help:
http://www.vm.ibm.com/progdir/4osasf42.pdf
Huegel, Thomas wrote:
This may be a lot easier than I thought.
It appears all of the code is on 2VMVMV20 mdisks all I have to do is run
a SES command to move them to production 200, 400 etc mdisks.
I am at a D/R site with limited resources, can anyone suggest what the
SES command might look like?
Thanks
-----Original Message-----
From: The IBM z/VM Operating System
To: [email protected]
Sent: 4/19/2007 3:29 PM
Subject: Re: Install mistake
Two alternatives:
If you have the tape layout, the you can restore the minidisks one by
one. I think each minidisk was separately DDRed.
If not: then you need to restore a whole VM and you use the directory
you just showed to extract the minidisks you want and DDR them from the
new packs onto minidisks of your current VM.
e.g. (after the restore to get MDISK 2C2 3390 3334 004 430W01 )
LINK 2VMVMV20 2C2 222 M (current VM)
ATTACH restored_430W01 * 111
DDR
SYS CONS#IN 111 DASD#OUT 222 DASD
COPY 3334 3337 reorder 0
And, you need more than OSASF 200 and 400: the 2VMVMV20 user contains
the real SW.
As for the link error: in the past, OSA/SF installed a stupid PROFILE
EXEC that tries to link to non-standard minidisk addresses. No need to
a MAINT 19A for example. I don't know if this is better in z/VM V5.
--
Kris Buelens,
IBM Belgium, VM customer support
--
Rich Smrcina
VM Assist, Inc.
Phone: 414-491-6001
Ans Service: 360-715-2467
rich.smrcina at vmassist.com
Catch the WAVV! http://www.wavv.org
WAVV 2007 - Green Bay, WI - May 18-22, 2007
