I took that out (it was in by virtue of a parm entry on the start command, but not in the config file). The link is working, but is very, very slow in terms of any of the counters shown by q system counts. Are there some good knobs to twist that will accelerate the process?
Regards, Richard Schuh -----Original Message----- From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On Behalf Of Rick Barlow Sent: Thursday, May 17, 2007 2:04 PM To: [email protected] Subject: Re: Message DMTNTR930E You shouldn't need STREAMS on a TCPNJE link. Are you sure you remembered to change it? All I have in my configuation is the following: LINKDEFINE TCPNODE TYPE TCPNJE DP 4 PARM TCPNODE HOSTNAME=SOME.NETWORK.NAME LCLPORT=175 RMTPORT=175 ____________________________________ Rick Barlow Systems Engineering Consultant Nationwide Services Co., Technology Solutions Mainframe, z/VM and System z Linux Support One Nationwide Plaza MB-02-201 Columbus OH 43215-2220 U.S.A Voice: (614) 249-5213 Fax: (614) 677-0821 mailto:[EMAIL PROTECTED] The IBM z/VM Operating System <[email protected]> wrote on 05/17/2007 04:57:43 PM: > [email protected] > > I converted a link to an MVS system from SNA to TCP/IP a few minutes ago. I > got these messages a few minutes ago: > DMTNTR930E Request to start stream 2 on link MVS1 for RCB X'A8' has > been denied, reason code 0000 > DMTNTR930E Link MVS1 stream 2 denied -- unknown reason > I am having a little bit of trouble diagnosing the problem because the doc. > says that the message is related to SNA, not IP, and there is > nothing telling me what RCB X'A8' reason code 0000 means. I have > drained and restarted the link with "STREAMS=1" added to the parm. > Is this the right answer to the problem? > Regards, > Richard Schuh
