Ian,
This is what is on the BASE z/VM 5.3.0 system
System_Identifier_Default ZVMV5R30
all terminals get the same System Identifier, we usually change ours to
Identify what VM system it is that is running.
Bill Munson
VM System Programmer
Office of Information Technology
State of New Jersey
(609) 984-4065
President MVMUA
http://www.marist.edu/~mvmua
[EMAIL PROTECTED] wrote:
Have you looked in your SYSTEM CONFIG file for
System_Identifier_Default? I bet it has an I10B after it.
Peter
-----Original Message-----
From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On
Behalf Of Ian S. Worthington
Sent: September 27, 2007 12:14
To: [email protected]
Subject: Code after RUNNING status?
My CMS ready prompt has a code after the RUNNING/VM READ/CP READ: I10B,
the
one I'm looking at at the moment.
I've always wondered what that meant. Anyone care to enlighten me?
For extra marks, suggestions of how to replace it with something useful,
maybe
like the userid of the screen I'm looking at so I stop getting them
confused,
would be much appreciated!
ian
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or privileged material. Any
review retransmission dissemination or other use of or taking of any action in
reliance upon this information by persons or entities other than the intended
recipient or delegate is strictly prohibited. If you received this in error
please contact the sender and delete the material from any computer. The
integrity and security of this message cannot by guaranteed on the Internet.
The Sender accepts no liability for the content of this e-mail or for the
consequences of any actions taken on basis of the information provided. The
recipient should check this e-mail and any attachments for the presence of
viruses. The sender accepts no liability for any damage caused by any virus
transmitted by this e-mail. This disclaimer is the property of the TTC and
must not be altered or circumvented in any manner.
