Normally you would change your LOGO configuration file with something
like:
Status VM_Read 'Feed CMS' ,
CP_Read 'Feed CP ' ,
Running 'Jogging ' ,
More 'Hit PA2 ' ,
Hold 'Hugging ' ,
Not_Accepted 'Not doin dat'
To change it to a CMS id would require writing code. I believe this was
discussed awhile back so I suggest checking the archives.
-----Original Message-----
From: The IBM z/VM Operating System
[mailto:[EMAIL PROTECTED] On Behalf Of Huegel, Thomas
Sent: Tuesday, December 18, 2007 2:16 PM
To: [email protected]
Subject: 3270 status area
At the bottom right of the z/VM screen the status area it says
RUNNING sys-id or CP READ sys-id or HOLDING sys-id etc. Other than
actually changing the system_identification in the SYSTEM CONFIG file
how can I change the sys-id that displays? I might want to do something
like place the CMS user ID there.
--------------------------------------------------------
This message w/attachments (message) may be privileged, confidential or
proprietary, and if you are not an intended recipient, please notify the
sender, do not use or share it and delete it. Unless specifically indicated,
this message is not an offer to sell or a solicitation of any investment
products or other financial product or service, an official confirmation of any
transaction, or an official statement of Merrill Lynch. Subject to applicable
law, Merrill Lynch may monitor, review and retain e-communications (EC)
traveling through its networks/systems. The laws of the country of each
sender/recipient may impact the handling of EC, and EC may be archived,
supervised and produced in countries other than the country in which you are
located. This message cannot be guaranteed to be secure or error-free. This
message is subject to terms available at the following link:
http://www.ml.com/e-communications_terms/. By messaging with Merrill Lynch you
consent to the foregoing.
--------------------------------------------------------
