NB: This email and its contents are subject to our email legal notice
which can be viewed at http://www.sars.gov.za/Email_Disclaimer.pdf
----
Paul, thanks for the handy exec.
The output shows all 10000+ allocated as PERM :
chkdisk 7e7d lnx000
Start of ICKDSF LIST
ICK030E DEFINE INPUT DEVICE: FN FT FM, "CONSOLE", OR "READER"
CONSOLE
ICK031E DEFINE OUTPUT DEVICE: FN FT FM, "CONSOLE", OR "PRINTER"
CONSOLE
ICKDSF - CMS/XA/ESA DEVICE SUPPORT FACILITIES 17.0
03/19/08 PAGE 1
ENTER INPUT COMMAND:
CPVOL LIST UNIT(7E7D) VFY(LNX000)
ICK00700I DEVICE INFORMATION FOR 7E7D IS CURRENTLY AS FOLLOWS:
PHYSICAL DEVICE = 3390
STORAGE CONTROLLER = 3990
STORAGE CONTROL DESCRIPTOR = E9
DEVICE DESCRIPTOR = 0C
ADDITIONAL DEVICE INFORMATION = 48001B35
TRKS/CYL = 15, # PRIMARY CYLS = 10017
ICK04000I DEVICE IS IN SIMPLEX STATE
ICK00091I 7E7D NED= 2105. .EMC.06.200000090745
ICK091I 7E7D NED= 2105. .EMC.06.200000090745
ICK03090I VOLUME SERIAL = LNX000
ICK03024I DEVICE IS CURRENTLY FORMATTED WITHOUT FILLER RECORDS
ICK03000I CPVOL REPORT FOR 7E7D FOLLOWS:
ICK03021I 7E7D IS FORMATTED FOR VM/ESA MODE
CYLINDER ALLOCATION CURRENTLY IS AS FOLLOWS:
TYPE START END TOTAL
---- ----- --- -----
PERM 0 10016 10017
ICK00001I FUNCTION COMPLETED, HIGHEST CONDITION CODE WAS 0
13:05:28 03/19/08
ENTER INPUT COMMAND:
END
ICK00002I ICKDSF PROCESSING COMPLETE. MAXIMUM CONDITION CODE WAS 0
Return code from ICKDSF was: 0
Done with LIST of: LNX000 - 7E7D
Date.... 19 Mar 2008 -- Time.... 13:06:01
Any further suggestions ?
PS : Detaching from System & logging onto LINUX02 I still get the
following :
HCPLNM1151E LINUX02 0100 has not been linked because it is not within CP
volume extents.
Kind Regards,
Vikesh Bhoola
-----Original Message-----
From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On
Behalf Of Feller, Paul
Sent: 19 March 2008 12:40 PM
To: [email protected]
Subject: Re: Mdisk 3390 Model 9 dasd
Did all of the cyls (10,000+) get allocated as PERM? Here is an EXEC I
use to check the status of a disk. Remember to DET the disk from the
system and ATT it to your ID. When I'm in a hurray I sometimes forget
that little bit of information.
/*--------------------------------------------------*/
/* */
/*--------------------------------------------------*/
Parse upper arg VDEV VOLID
/*--------------------------------------------------*/
/* */
/*--------------------------------------------------*/
say 'Start of ICKDSF LIST'
push 'end';
push 'CPVOL LIST UNIT('VDEV') VFY('VOLID')';
push 'console';
push 'console';
'ickdsf'
say
say 'Return code from ICKDSF was:' rc
say 'Done with LIST of:' VOLID '-' VDEV
say 'Date....' DATE() '-- Time....' TIME('N')
Exit
Paul Feller
AIT Mainframe Technical Support
[EMAIL PROTECTED]
(319)-355-7824
