Aw geez, this is getting to detailed. I just saw a chance to elbow Chuckie in the ribs and jumped on it. I think that David got the point right off. :-)
But it's interesting to know the details anyway. Mike Walter ----- Original Message ----- From: "Imler, Steven J" [EMAIL PROTECTED] Sent: 05/02/2008 09:09 PM AST To: [email protected] Subject: Re: Problem with stacked ddr tape and possible DYNAM Not to beat the dead horse ... but Mike is correct in assuming that Dynam/T VM does not currently have support for MULTIUSER ATTACH or recognition of it. For those on the list that run VM:Tape, it does (via DEBUG setting) ... there are a few of you using it (and yes, it was coordinated with DFSMS/VM [RMSMASTR] support). JR (Steven) Imler CA Senior Software Engineer Tel: +1 703 708 3479 Fax: +1 703 708 3267 [EMAIL PROTECTED] > -----Original Message----- > From: The IBM z/VM Operating System > [mailto:[EMAIL PROTECTED] On Behalf Of Mike Walter > Sent: Friday, May 02, 2008 06:43 PM > To: [email protected] > Subject: Re: Problem with stacked ddr tape and possible DYNAM > > And of course it could be updated, but they probably have to > weigh the cost vs other new things that development could be > doing. So goes the "Song of Chuckie"... ;-) > > Mike Walter > > > ----- Original Message ----- > From: "Stephen Frazier" [EMAIL PROTECTED] > Sent: 05/02/2008 05:14 PM EST > To: [email protected] > Subject: Re: Problem with stacked ddr tape and possible DYNAM > > > > I bet because the code was written before multiuser attach > support existed. > > Les Geer (607-429-3580) wrote: > > > > Curious as to why a tape give is issued here rather than exploiting > > the multiuser attach support in RMS > > > > Best Regards, > > Les Geer > > IBM z/VM and Linux Development > > -- > Stephen Frazier > Information Technology Unit > Oklahoma Department of Corrections > 3400 Martin Luther King > Oklahoma City, Ok, 73111-4298 > Tel.: (405) 425-2549 > Fax: (405) 425-2554 > Pager: (405) 690-1828 > email: stevef%doc.state.ok.us > > > > The information contained in this e-mail and any accompanying > documents may contain information that is confidential or > otherwise protected from disclosure. If you are not the > intended recipient of this message, or if this message has > been addressed to you in error, please immediately alert the > sender by reply e-mail and then delete this message, > including any attachments. Any dissemination, distribution or > other use of the contents of this message by anyone other > than the intended recipient is strictly prohibited. All > messages sent to and from this e-mail address may be > monitored as permitted by applicable law and regulations to > ensure compliance with our internal policies and to protect > our business. E-mails are not secure and cannot be guaranteed > to be error free as they can be intercepted, amended, lost or > destroyed, or contain viruses. You are deemed to have > accepted these risks if you communicate with us by e-mail. > > The information contained in this e-mail and any accompanying documents may contain information that is confidential or otherwise protected from disclosure. If you are not the intended recipient of this message, or if this message has been addressed to you in error, please immediately alert the sender by reply e-mail and then delete this message, including any attachments. Any dissemination, distribution or other use of the contents of this message by anyone other than the intended recipient is strictly prohibited. All messages sent to and from this e-mail address may be monitored as permitted by applicable law and regulations to ensure compliance with our internal policies and to protect our business. E-mails are not secure and cannot be guaranteed to be error free as they can be intercepted, amended, lost or destroyed, or contain viruses. You are deemed to have accepted these risks if you communicate with us by e-mail.
