I believe Jim Vincent had a session or two at SHARE on how to do this. You might check SHARE.ORG for past sessions
good luck Bill Munson VM System Programmer 201-418-7588 President MVMUA http://www2.marist.edu/~mvmua/ Robert J Brenneman <[EMAIL PROTECTED]> Sent by: The IBM z/VM Operating System <[email protected]> 06/05/2008 03:46 PM Please respond to The IBM z/VM Operating System <[email protected]> To [email protected] cc Subject Re: I know SES can do this - but how? That won't really work for me since the directory entries are already there, there's just no real disk at those addresses. I could start hacking stuff out of the 4OSASF40 PPF files, but I don't really want to do that. I could swear there was a way to tell SES "this product is already up to date - ignore that stuff you received for it" but for the life of me I can't find that incantation in the books. On Thu, Jun 5, 2008 at 3:32 PM, Crabtree, Anne D <[EMAIL PROTECTED]> wrote: I may be totally wrong, but I happened to be running service on z/vm 5.3 yesterday and the SERVICE step failed on 4OSASF40 also. I had all userids commented out in my user directory. I just removed comments and did directxa and then restarted service. I figure I can just take them back out when I'm done? Hope that helps. -- Jay Brenneman *************************** IMPORTANT NOTE***************************** The opinions expressed in this message and/or any attachments are those of the author and not necessarily those of Brown Brothers Harriman & Co., its subsidiaries and affiliates ("BBH"). There is no guarantee that this message is either private or confidential, and it may have been altered by unauthorized sources without your or our knowledge. Nothing in the message is capable or intended to create any legally binding obligations on either party and it is not intended to provide legal advice. BBH accepts no responsibility for loss or damage from its use, including damage from virus. ************************************************************************
