I would really appreciate if you could share what you have. We, also, will
have no tapes attached to the VM system.
Thanks and Regards,
Jihad K. Kawkabani
IT Systems Engineer Consultant
Voice: 440.395.0740
Network: 575.0740
Cell: 440.465.2969
Mike Harding
<[EMAIL PROTECTED]
p.org> To
Sent by: The IBM [email protected]
z/VM Operating cc
System
<[EMAIL PROTECTED] Subject
ARK.EDU> Re: List of messages candidates for
automation
11/11/2008 01:59
PM
Please respond to
The IBM z/VM
Operating System
<[EMAIL PROTECTED]
ARK.EDU>
I went through this exercise a few months back, working first through
Messages and Codes and picking out those messages I thought to be of
interest for our shop. As we use IBM's Operations Manager for VM, I then
formatted those into rule definitions for OpsMgr, matching against HCPMES
REPOS to get the message text which I formatted into comments to go along
with the rule defs in OpsMgr's config. I'd be happy to share, but
unfortunately for general use, I ignored anything to do with tapes or tape
libraries as we don't have VM access to any.
The IBM z/VM Operating System <[email protected]> wrote on
11/11/2008 09:21:49 AM:
> CP Messages and Codes is probably a good place to start. I've got some
> airplane time coming up, so I'll have a look and see if we can be
systematic
> about this and start a fairly comprehensive list.
>
> IBM, is there a location where all the message codes currently defined
are
> available? I suppose I could check MAINT 19D for help files, but if
there
> was a message repository, that's easier to process.
>
>
> On 11/11/08 10:02 AM, "Jihad K Kawkabani"
> <[EMAIL PROTECTED]> wrote:
>
> > The plan is to use VM as a floor system to run MQ under Linux. We
already
> > have monitoring and automation that we will carry from the previous
hosts
> > for the guests. We justified zLinux financially, so we have justified
the
> > bare necessary to run (RACF, Performance tool kit, and Dirmaint). I
will be
> > using PROP to send these messages to a monitored console, if I cannot
deal
> > with them via a REXX exec, or other CP command actions, so I do not
want
> > that console cluttered with messages, hence my question.
