We are on DS8100, so we created a bunch of 3390-1s for paging.

Bob.

-----Original Message-----
From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On
Behalf Of Tom Duerbusch
Sent: Wednesday, December 10, 2008 11:01 AM
To: [email protected]
Subject: Re: Paging subsystem

IF you end up paging heavily,
THEN you want many volumes
AND you want the volumes on separate RAID arrays as possible.

After that...my guess is if you have, say, 4-6 mod-3s per array, it might be
time to move to less mod-9s.

But if you are really in that much paging, add more memory.  On a z10 it is
much less expensive.  On the other boxes, look at the used market.

Of course if you have sufficient disk space to waste, use mod-9s and add
more when they are 10-15% full.  (Some shops make stupid IMHO rules like
everything must be mod-9s, but there are a limited number of addresses in
the dasd subsystem, and disk drives can be very large).

Tom Duerbusch
THD Consulting



>>> "Bauer, Bobby (NIH/CIT) [E]" <[EMAIL PROTECTED]> 12/10/2008 10:09 
>>> AM >>>
I got a great Christmas present! 8G dedicated to our new z/VM and zLinux
pilot and new ficon attached DASD (9990V) to replace the escon DASD. The new
DASD has both mod3 and mod9.
As an old MVS dinosaur I'd create many different paging volumes on smaller
disk (mod3) but there is some pressure to use the mod9's. It is a pilot so I
have no idea what our load is going to look like. Obviously my mileage may
vary but what is in use out there? Any thoughts, good or bad, about a mod9
for paging other than the possibility of contention?

Thanks

Bobby Bauer
Center for Information Technology
National Institutes of Health
Bethesda, MD 20892-5628
301-594-7474

This electronic transmission and any documents accompanying this electronic 
transmission contain confidential information belonging to the sender.  This 
information may be legally privileged.  The information is intended only for 
the use of the individual or entity named above.  If you are not the intended 
recipient, you are hereby notified that any disclosure, copying, distribution, 
or the taking of any action in reliance on or regarding the contents of this 
electronically transmitted information is strictly prohibited.

Reply via email to