Try this set pf11 delay q dasd details
"Wakser, David"
<david.wak...@inf
ocrossing.com> To
Sent by: The IBM [email protected]
z/VM Operating cc
System
<[email protected] Subject
ARK.EDU> Re: Set PFxx Question.
02/25/2009 02:22
PM
Please respond to
The IBM z/VM
Operating System
<[email protected]
ARK.EDU>
Howard:
For example, I use the following to set PF13 to VSECMD. I type in the
command that I want to send, and press PF13. The SUBSTITU "&*" I believe
are the things you are missing.
"CP SET PF13 SUBSTITU IMMED VSECMD UNIPROD &*"
David Wakser
From: The IBM z/VM Operating System [mailto:[email protected]] On
Behalf Of Howard Rifkind
Sent: Wednesday, February 25, 2009 2:16 PM
To: [email protected]
Subject: Set PFxx Question.
Did this a few times in the past but can't remember how to do this again.
I want to SET PFxx lets say PF11 as follows:
SET PF11 Q DASD DETAILS
Then when I hit the PF11 key I just want to fill in the address. I've
tried the after and before versions and the Q DASD DETAILS shows up and it
indicates an error. Never gives me the change to key in anything, I just
want the command to sit on the screen and wait.
So, how can I just hit PF11 have it show Q DASD DETAILS and stay on the
screen so I can key in the address I want?
Thanks.
The when I
_____________
LEGAL NOTICE
Unless expressly stated otherwise, this message is
confidential
and may be privileged. It is intended for the
addressee(s) only.
Access to this E-mail by anyone else is
unauthorized.
If you are not an addressee, any disclosure or
copying of the
contents of this E-mail or any action taken (or
not taken) in
reliance on it is unauthorized and may be
unlawful. If you are not an
addressee, please inform the sender immediately,
then delete this
message and empty from your trash.
