Hi Mike,
No luck yet. We are watching the install run now and we can see the MAC
address that was assigned along with it's IP address when we display the
vswitch with details. We changed the porttype from trunk to access and
defined the NIC. We should find out shortly if the install is successful
or not.
It fails during the re-boot of the install when it starts to perform the
install from the disk information that was created. It fails at the same
point everytime.
..done
Enabling syn flood protection..done
Disabling IP forwarding..done
Disabling IPv6 forwarding..done
Enabling IPv6 autoconfig..done
Disabling IPv6 privacy..done
..done
Mounting securityfs on /sys/kernel/security ..done
Loading AppArmor module ..done
Loading AppArmor profiles ..done
System Boot Control: The system has been set up
Failed features: [80C [16Dboot.udev
System Boot Control: Running /etc/init.d/boot.local
[1A..doneStarting syslog services..done
Starting D-BUS daemon..done
Starting HAL daemon..done
Setting up network interfaces:
lo
lo IP address: 127.0.0.1/8
Checking for network time protocol daemon (NTPD): ..unused
Can't determine current runlevel
[1A..doneWaiting for mandatory devices: eth-id-02:00:51:50:00:00
__NSC__
19 18 17 16 15 14 13 12 11 10 9 7 6 5 4 3 2 1 0
eth-id-02:00:51:50:00:00 No interface found
[1A..failedSetting up service network . . . . . . . . . . .
. . .
. ...failed
ip_tables: (C) 2000-2006 Netfilter Core Team
Jul 6 12:51:30 linux kernel: ip_tables: (C) 2000-2006 Netfilter Core
Team
It does not see the MAC address in the VM system for some reason. Even
though during the initial phase of the install it does see it.
Russell Gendreau
Time Customer Service, Inc.
813-554-2064
________________________________
From: The IBM z/VM Operating System [mailto:[email protected]] On
Behalf Of Michael MacIsaac
Sent: Tuesday, July 07, 2009 10:56 AM
To: [email protected]
Subject: Re: Updated paper available - "Sharing and maintaining SLES 10
SP2 Linux under z/VM"
Russel,
> Have you been successful with the install over an OSA defined on a
layer 2 network?
>
> We are running z/VM 5.4 with the latest PTF's and SUSE 10 SP2 trying
to perform the install using the IBM scripts.
> It is failing every time during the re-boot phase of the install.
If you are asking about the subject paper, no we did not. We used a
default VSWITCH which is layer 3.
I thought there were previous threads describing the correct PARMFILE
variables to allow the install to succeed with a layer 2 VSWITCH.
Oh, those threads were probably on the linux-390 mailing list. That
list can be searched here:
http://www2.marist.edu/htbin/wlvindex?linux-390
and here:
http://www.mail-archive.com/linux-390%40vm.marist.edu/
Hope this helps.
"Mike MacIsaac" <[email protected]> (845) 433-7061
