Hi, Rich I have zVSE 4.2.1 in a 5 Virtual Machines, and one with VSE/ESA 2.6.2.
Best Regards, Mario Izaguirre Mainframe System Programmer Barcelona, Spain -----Mensaje original----- De: The IBM z/VM Operating System [mailto:[email protected]] En nombre de Rich Smrcina Enviado el: jueves, 22 de julio de 2010 13:04 Para: [email protected] Asunto: Re: TCPIP Dynamic Definition The TCP/IP Obeyfile command can be used to dynamically modify the stack, but unfortunately you can not add or remove DEVICE or LINK statements. If you know you will be adding VSE machines in the future, you may want to 'pre-configure' TCP/IP with DEVICE and LINK statements for a normal shutdown/restart cycle so that they are available when a VSE system is added. Then the HOME/GATEWAY/START statements can be added dynamically. What release are these VSE systems? If they are newer than VSE/ESA 2.6/2.7, it may be better to try to convert them to a disconnected VSwitch. This way there is no playing around with device addresses and point-to-point links. The VSE systems see the disconnected VSwitch just like any other QDIO device. On 07/22/2010 04:22 AM, Mario Izaguirre wrote: > > Hi all: > > I have six VSE virtual machines under z/VM, each machine has an IP > address that is used to couple the TCPIP of z/VM and so each virtual > machine to go through this point to the LAN of my company, now the > problem I have is that every time I register a new VSE virtual > machine, I have to modify the TPCIP PROFILE of the user TCPMAINT and > to make the change I have to give the LOGOFF command at the TCPIP of > z/VM, the question that I want to make is: > > I can I dynamically set the TCPIP of z/VM, these definitions of CTC > and so I do not have to be dropping the TCPIP service? > > Best Regards, > > /Mario Izaguirre/ > > Mainframe System Programmer > > Barcelona, Spain > -- Rich Smrcina Phone: 414-491-6001 http://www.linkedin.com/in/richsmrcina Catch the WAVV! http://www.wavv.org WAVV 2011 - April 15-19, 2011 Colorado Springs, CO
