--- Start of Idrisi List message
Hi all,
I suppose the following may sound a relatively stupid question, yet the
issue is causing me quite a bit of delay, and I would like to solve it, if
possible.
I have xyz files (extracted from contours) that I have to convert into a
DEM. I have imported them xyzidris, then I used interpol to obtain the
dem. All fine, but just before beginning the very operation, Idrisi
complains: 'Vector file contains too many points (maximum is 16000)'. I
have downcutted the file to 8000 points, but the Idrisi just wouldn't go
ahead altogether. Beside, the downcutting operation is quite consuming,
virtually manual copy and paste, and it also leads to file segmentation,
which is not quite what I'm crazy for, after all..
I tend to imagine the solution is relatively easy... Would anybody out
there have a suggestion?
Many thanks in advance for your patience!
Umberto Fracassi
---------------------------------------------------------------
Dip.to di Scienze della Terra
Universita' di Firenze
Via G. la Pira, 4
50121 Firenze
Italy
Tel: +39-055-2757522
Fax: +39-055-218628
Email: [EMAIL PROTECTED]
WWW: http://ewse.ceo.org/construct/build.pl/665027
---------------------------------------------------------------
--- End of Idrisi List message
IDRISI-L is an unmoderated list. As a service to list users, please post a
summary of useful responses to your questions.
To post a message to IDRISI-L, send it to [EMAIL PROTECTED] To
subscribe to the list, send an email from the address to be subscribed to
[EMAIL PROTECTED] with "subscribe" (without quotes) as the first line
of the message body. To unsubscribe, do the same, only with "unsubscribe"
as the first line of the message body.
