Hi,
I have sent some questions regarding the IF_Num of DSMAP TLV before. I'd like
to make sure it is not lost.
2.1. New address type for Downstream Mapping TLV
The new address type indicates that no address is present in the
DSMAP or DDMAP TLV. However, IF_Num information (see definition of
"IF_NUM" in [I-D.ietf-mpls-tp-identifiers]) for both ingress and
egress interfaces, as well as multipath information is included in
the format and MAY be present.
I believe the "IF_Num" can be used for per-interface MIP model.
But I'm not sure why we need use both "ingress IF_Num" and "egress IF_Num" in a
DSMAP TLV.
I can't find this case (Ingress_IF::Egress_IF) in
[I-D.ietf-mpls-tp-identifiers].
e.g.) the following are defined in [I-D.ietf-mpls-tp-identifiers] using
"IF_Num", but there is no Ingress_IF::Egress_IF.
- "IF_ID"
IF_ID is a 64-bit identifier formed as Node_ID::IF_Num.
- "MIP ID"
For a MIP which is associated with particular interface, we simply
use the IF_ID (see Section 4) of the interfaces which are cross-
connected.
If have any special means in the "IF_Num", I think MUST mention it clearly.
Also I feeling that this draft have to clarify the responder's behavior for
each IF information of the "IF_Num".
Best regards,
zhenlong
> -----Original Message-----
> From: mpls-boun...@ietf.org [mailto:mpls-boun...@ietf.org] On Behalf Of The
> IESG
> Sent: Thursday, August 11, 2011 10:46 PM
> To: IETF-Announce
> Cc: m...@ietf.org
> Subject: [mpls] Last Call: <draft-ietf-mpls-tp-on-demand-cv-06.txt>
> (MPLSOn-demand Connectivity Verification and Route
> Tracing) toProposed Standard
>
>
> The IESG has received a request from the Multiprotocol Label Switching WG
> (mpls) to consider the following document:
> - 'MPLS On-demand Connectivity Verification and Route Tracing'
> <draft-ietf-mpls-tp-on-demand-cv-06.txt> as a Proposed Standard
>
> The IESG plans to make a decision in the next few weeks, and solicits
> final comments on this action. Please send substantive comments to the
> ietf@ietf.org mailing lists by 2011-08-25. Exceptionally, comments may be
> sent to i...@ietf.org instead. In either case, please retain the
> beginning of the Subject line to allow automated sorting.
>
> Abstract
>
> Label Switched Path Ping (LSP-Ping) is an existing and widely
> deployed Operations, Administration and Maintenance (OAM) mechanism
> for Multi-Protocol Label Switching (MPLS) Label Switched Paths
> (LSPs). This document describes extensions to LSP-Ping so that LSP-
> Ping can be used for On-demand Connectivity Verification of MPLS
> Transport Profile (MPLS-TP) LSPs and Pseudowires. This document also
> clarifies procedures to be used for processing the related OAM
> packets. Further, it describes procedures for using LSP-Ping to
> perform Connectivity Verification and Route Tracing functions in
> MPLS-TP networks. Finally this document updates RFC 4379 by adding a
> new address type and requesting an IANA registry.
>
>
> The file can be obtained via
> http://datatracker.ietf.org/doc/draft-ietf-mpls-tp-on-demand-cv/
>
> IESG discussion can be tracked via
> http://datatracker.ietf.org/doc/draft-ietf-mpls-tp-on-demand-cv/
>
>
> No IPR declarations have been submitted directly on this I-D.
> _______________________________________________
> mpls mailing list
> m...@ietf.org
> https://www.ietf.org/mailman/listinfo/mpls
_______________________________________________
Ietf mailing list
Ietf@ietf.org
https://www.ietf.org/mailman/listinfo/ietf
