In a terminal type
screen /dev/ttyUSB2
if it fails /dev/ttyUSB0
1
3
then issue the command
AT+CSQ
you will receive a message like
xx,yy
xx can vary from 00 to 25
xx < 15, signal insufficient
xx>15, good signal
or xx indicates signal strength.
yy is info regarding bit error rate.
forgot the link where I found this info. But I am using method.
Jemshid
On 4 January 2011 22:19, Shino Jacob <[email protected]> wrote:
> is there any signal monitor tool available for evdo (Capitel modem)
>
> --
> Miles to go before I Sleep
>
> --
> "Freedom is the only law".
> "Freedom Unplugged"
> http://www.ilug-tvm.org
>
> You received this message because you are subscribed to the Google
> Groups "ilug-tvm" group.
> To control your subscription visit
> http://groups.google.co.in/group/ilug-tvm/subscribe
> To post to this group, send email to [email protected]
> To unsubscribe from this group, send email to
> [email protected]
>
>
>
> For details visit the google group page:
> http://groups.google.com/group/ilug-tvm?hl=en
>
--
"Freedom is the only law".
"Freedom Unplugged"
http://www.ilug-tvm.org
You received this message because you are subscribed to the Google
Groups "ilug-tvm" group.
To control your subscription visit
http://groups.google.co.in/group/ilug-tvm/subscribe
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For details visit the google group page:
http://groups.google.com/group/ilug-tvm?hl=en
