> ---------- > From: Stefano C.A. Rossi[SMTP:[EMAIL PROTECTED]] > Sent: Tuesday, October 05, 1999 4:17:47 PM > To: Ilwis-List > Subject: R: tunnel tolerance > Auto forwarded by a Rule > Thankyou for your explanation. Best regards and have a nice job! Stefano -----Messaggio originale----- Da: Ilwis-List <[EMAIL PROTECTED]> A: Ilwis-List <[EMAIL PROTECTED]> Data: marted� 5 ottobre 1999 9.12 Oggetto: FW: tunnel tolerance > > >> ---------- >> From: Ilwis Support >> Sent: Tuesday, October 05, 1999 9:16:39 AM >> To: Ilwis-List >> Subject: RE: tunnel tolerance >> Auto forwarded by a Rule >> >Dear Stefano, > >Unfortunately, it is not possible to save/maintain the Tunnel Tolerance and >Snap Tolerance values (in meters) in the segment editor. Each time a segment >map is opened in the editor, default values are calulated: >Snap Tolerance: the default snap tolerance is calculated as: the largest >coordinate range, i.e. Xmax-Xmin or Ymax-Ymin as defined by the map's >boundaries, divided by 150. > >Tunnel tolerance:the default tunnel tolerance is calculated as the largest >coordinate range, i.e. Xmax-Xmin or Ymax-Ymin as defined by the map's >boundaries, divided by 1500. > > >Kind regards, > >Jelger Kooistra >------------------------------------------- >Jelger Kooistra, ILWIS Support Officer >ITC - ILWIS Department >PO Box 6, 7500 AA Enschede, The Netherlands >phone: +31 53 4874217 fax: +31 53 4874484 >http://www.itc.nl/ilwis/dev/support >------------------------------------------- > >> ---------- >> From: Stefano C.A. Rossi[SMTP:[EMAIL PROTECTED]] >> Sent: Thursday, September 23, 1999 11:25:27 PM >> To: ilwis >> Subject: tunnel tolerance >> Auto forwarded by a Rule >> >> Dear ILWIS users, >> it is possible to save and maintain the value of the item "tunnel >> tolerance" as, e.g., for the snap value? >> Thankyou >> Stefano Rossi >> Geologist
