Thomas, The List sends the file syntax.txt in this case. Do you see that file in the \list folder under that domains folder? It should be there. If you find one in another location, just copy it there. If not, I've attached a copy. Daniel Donnelly ________________________________________________________ ----- Original Message ----- From: "Thomas Köppe" <[EMAIL PROTECTED]> To: "IMail Forum" <[EMAIL PROTECTED]> Sent: Wednesday, April 11, 2001 8:09 AM Subject: [IMail Forum] Mailings list problems > Hi, > > I have setup a (non-IP) virtual host with one mailing list. > The list works very fine, but if I try to send a message > to [EMAIL PROTECTED] with the body "help" I > receive an empty message. The subject of the message > is: Groupsrv help message > > If I send one with the body "help <listname>" then I receive > the normal help message for this list. > Any ideas why the first message is empty? > Thanks. > > Regards, > Thomas > > > Please visit http://www.ipswitch.com/support/mailing-lists.html > to be removed from this list. > > An Archive of this list is available at: > http://www.mail-archive.com/imail_forum%40list.ipswitch.com/ >
IMail List Server for Windows NT, Ipswitch, Inc. -------------------------------------------------------------------- Valid Commands are: To subscribe to a list, send a mail message to "imailsrv" at this address with the following in the body of the message: subscribe listname your_full_name To unsubscribe from a list, send a mail message to "imailsrv" at this address with the following in the body of the message: unsubscribe listname To receive a list of the lists supported here: list To receive a list of users on a given list (If enabled for that particular list): list listname To receive help send: help [listname] To change to digest mode, send a mail message to "imailsrv" at this address with the following in the body of the message: set mode digest listname To change back to standard mode, send a mail message to "imailsrv" at this address with the following in the body of the message: set mode standard listname
