I can't say I remember how to do this, mainly because I created TrashFinder
Gateway for this purpose (filtering mail and then forwarding). (I still use
EMWAC to deliver the mail to POP3 mailboxes internal to our network, but
that's it.) My recollection is that what you've done is essentially correct
(I have my EMWAC pointed at the Gateway to filter and deliver outbound
mail). But I don't know if it is possible to use it to forward mail that is
destined for the local network. Perhaps you need to tell it not to accept
mail for any domain (in that case, it acts as a relay)?
Randy.
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf Of Ted Wiggins
> Sent: Wednesday, February 01, 2012 12:18 PM
> To: [email protected]
> Subject: Anyone still using EMWAC?
>
> Hi,
>
> I was hoping to put a little EMWAC MTA in front of an
> existing mail server to filter some of the incoming SMTP
> traffic. Mostly to eliminate some of the obvious trash from
> open relays and the like. I setup a server with Win2003 and
> installed the EMWAC stuff as well as the SCSmfilter and such
> and have been able to get the server accepting mail, but
> cannot seem to get it to forward the mail afterwards. It
> always places the message into the persons local mailbox. So
> I have obviously forgotten how to set this up. I have added
> the IP of the other MTA into the EMWAC IMS 0.80 Control Panel
> tool. I thought that was all that was required, but must be
> mistaken. Anyone still out there that remembers how to do this?
>
> thanks
> -ted
> This is the discussion list for the IMS Free email server software.
> To unsubscribe send mailto:[email protected]
>
> Delivered by MailSite Collaborator
> http://www.mailsite.com/
>
This is the discussion list for the IMS Free email server software.
To unsubscribe send mailto:[email protected]
Delivered by MailSite Collaborator
http://www.mailsite.com/
