|
you have to modify the module file in the CVSROOT.
I just discovered this and I'm having trouble modifying it without causing side
effects, could someone give a real simple "how to" on this subject? I tried
following the manual and had no luck. First try I would get junk after the
module name and second try I couldn't check out or update the modules with
another computer, so I ended up just returning the modules file back to its
original version.
Alan Jahns
----- Original Message -----
Sent: Tuesday, April 25, 2000 9:28
AM
Subject: List Modules in WinCVS doesn't
work
I have WinCVS 1.1b10 installed with TCL. The Console is
enabled, I can type in commands. But the "List Modules On The Server" command
under Admin --> Macros Admin does not work. It exits normally with Code 0,
but no list. There are modules to be listed.
Any ideas why this is
so?
Thanks!
Peter Pascale
[EMAIL PROTECTED]
I have WinCVS 1.1b10 installed with TCL. The
Console is enabled, I can type in commands. But the "List Modules On The
Server" command under Admin --> Macros Admin does not work. It exits
normally with Code 0, but no list. There are modules to be listed. Any ideas
why this is so?
Thanks!
Peter Pascale
[EMAIL PROTECTED]
|
