Hi Ruprecht, You Wrote > possible a portproblem on you windows box
Any ideas on how to figure out what the problem could be? > that is normal I've read. Yes - from what I read too, this is normal and I was expecting this to occur on the Windows box, but it did not happen. Thanks -- Manoj Thakur -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Wednesday, October 03, 2001 2:10 PM To: [EMAIL PROTECTED]; Manoj Thakur; [EMAIL PROTECTED] Cc: Manoj S Thakur (E-mail) Subject: Re: Problem logging cvs on Windows Am Mit, 03 Okt 2001 schrieb Manoj Thakur: > Hello, > > I just installed WinCVS on my Windows 2000 machine and was getting errors > while logging into the cvs server. > > So, I ran the cvs command (as shown below) in a windows command window. > ----------------------------- > H:\test_cvs>cvs -d ":pserver:mthakur@cvsserver:/vp/cvs_repository" login > Logging in to :pserver:mthakur@cvsserver:2401/vp/cvs_repository > CVS password: ******* > cvs [login aborted]: unrecognized auth response from cvsserver: Unknown > command: `' > > H:\test_cvs>cvs -version > > Concurrent Versions System (CVS) NT 1.11.1.1 Beta 4 (Local Build 7) > (client/server) > ----------------------------- > > Then, I logged onto the linux cvs server machine (cvsserver) and essentially > ran the same command, this time it was successful (as shown below) > ----------------------------- > cvsserver:mthakur 512$ cvs -d > ':pserver:mthakur@cvsserver:/vp/cvs_repository' login > (Logging in to mthakur@cvsserver) > CVS password: > cvsserver:mthakur 513$ cvs -version > > Concurrent Versions System (CVS) 1.11 (client/server) > ----------------------------- > > Any ideas?? > > (The cvs service is installed on a Linux machine, std cvs port of 2401. > If I run "telnet cvsserver 2401" on the windows machine, it immediately > returns with the first line stating "Unknown command: `'" and then basically > I get the 'cvs <anyInvalidOptionHere>' output. possible a portproblem on you windows box > >From the Linux box (or a SunOS box), the telnet command waits, till I hit > 'Enter', when it gives the return value as "cvs [pserver aborted]: bad auth > protocol start: ") > that is normal I've read. Pserver seams to be difficult to set up. I have problems in setting up too and think I'm turn around. Regards, Ruprecht _______________________________________________ Info-cvs mailing list [EMAIL PROTECTED] http://mail.gnu.org/mailman/listinfo/info-cvs
