OK, so I just started a clean NMake build and it does get past the problems I was encountering.
I don't know what I did differently, if anything. -- Kent Williams [email protected] On 11/5/12 9:26 AM, "Bill Hoffman" <[email protected]> wrote: >On 11/2/2012 5:20 PM, Williams, Norman K wrote: >> Other fun time-wasters -- apparently the CMake 2.8.10 NMake generator >> doesn't work right, or it didn't earlier today, so I'm back to using the >> Visual Studio Generator. The fun never stops. >Can you elaborate on what does not work? > >Thanks. > >-- >Bill Hoffman >Kitware, Inc. >28 Corporate Drive >Clifton Park, NY 12065 >[email protected] >http://www.kitware.com >518 881-4905 (Direct) >518 371-3971 x105 >Fax (518) 371-4573 ________________________________ Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and may be legally privileged. If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, then delete it. Thank you. ________________________________ _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Kitware offers ITK Training Courses, for more information visit: http://kitware.com/products/protraining.php Please keep messages on-topic and check the ITK FAQ at: http://www.itk.org/Wiki/ITK_FAQ Follow this link to subscribe/unsubscribe: http://www.itk.org/mailman/listinfo/insight-developers
