From: Faizal Rahim <[email protected]> autoneg_failed in struct igc_mac_info is never set in the igc driver. Remove the field and the dead code checking it in igc_config_fc_after_link_up().
The field originates from the e1000/e1000e fiber/serdes forced-link path, where MAC-level autoneg timeout sets it to signal the flow-control code to force pause. igc supports only copper, so it never needs to set this field. Reviewed-by: Looi Hong Aun <[email protected]> Reviewed-by: Aleksandr Loktionov <[email protected]> Signed-off-by: Faizal Rahim <[email protected]> Signed-off-by: Khai Wen Tan <[email protected]> --- drivers/net/ethernet/intel/igc/igc_hw.h | 1 - drivers/net/ethernet/intel/igc/igc_mac.c | 16 +--------------- 2 files changed, 1 insertion(+), 16 deletions(-) diff --git a/drivers/net/ethernet/intel/igc/igc_hw.h b/drivers/net/ethernet/intel/igc/igc_hw.h index be8a49a86d09..86ab8f566f44 100644 --- a/drivers/net/ethernet/intel/igc/igc_hw.h +++ b/drivers/net/ethernet/intel/igc/igc_hw.h @@ -92,7 +92,6 @@ struct igc_mac_info { bool asf_firmware_present; bool arc_subsystem_valid; - bool autoneg_failed; bool get_link_status; }; diff --git a/drivers/net/ethernet/intel/igc/igc_mac.c b/drivers/net/ethernet/intel/igc/igc_mac.c index 7ac6637f8db7..142beb9ae557 100644 --- a/drivers/net/ethernet/intel/igc/igc_mac.c +++ b/drivers/net/ethernet/intel/igc/igc_mac.c @@ -438,28 +438,14 @@ void igc_config_collision_dist(struct igc_hw *hw) * Checks the status of auto-negotiation after link up to ensure that the * speed and duplex were not forced. If the link needed to be forced, then * flow control needs to be forced also. If auto-negotiation is enabled - * and did not fail, then we configure flow control based on our link - * partner. + * then we configure flow control based on our link partner. */ s32 igc_config_fc_after_link_up(struct igc_hw *hw) { u16 mii_status_reg, mii_nway_adv_reg, mii_nway_lp_ability_reg; - struct igc_mac_info *mac = &hw->mac; u16 speed, duplex; s32 ret_val = 0; - /* Check for the case where we have fiber media and auto-neg failed - * so we had to force link. In this case, we need to force the - * configuration of the MAC to match the "fc" parameter. - */ - if (mac->autoneg_failed) - ret_val = igc_force_mac_fc(hw); - - if (ret_val) { - hw_dbg("Error forcing flow control settings\n"); - goto out; - } - /* In auto-neg, we need to check and see if Auto-Neg has completed, * and if so, how the PHY and link partner has flow control * configured. -- 2.43.0
