Ok, we have a few interfaces on Cisco switches that IM report Errors on.
Normally, the link looks like this:
Interface Information(ifIndex = 25)
Device Name:RDSAS_Leeds_MDF
Description:FastEthernet0/24
Name:Fa0/24
Alias:NPAS LAN Trunk
Type:100 MBit ethernetCsmacd(MTU=1500)
Status:UP for 3 days, 4 hours
MAC Address:00-04-28-D0-C4-D8
Interface Statistics
(of100 MBitbandwidth)
Percent Err:100%(112pkts w/o error)
Transmit Statistics(0.0% utilization)
(0.0% mcast,0.0% bcast)
(0bps)
(0errors)
(0discards)
Percent Err:0.0%(112pkts w/o error)
Receive Statistics(0.0% utilization)
(0.0% mcast,0.0% bcast)
(0bps)
(5errors)
(0discards)
Percent Err:100%(0pkts w/o error)
Last updated Aug 23, 17:04:12; sample: 30.77 seconds.
The big question here is: Where the ***** does it get the errors from? The interface seem to report no packets and no bytes at all. Does that mean that the Pkt/Second and Byte/Second is the ones WithOut errors?
Does these numbers come from the switch, or is it wrongly reported by IM?
____________________________________________
Jakob Peterh�nsel
Technical Engineer
Tel: +45 7022 1014
Fax: +45 7022 1013
Mob: +45�22 68 49 61
[EMAIL PROTECTED]
www.NetPoint.com
<<inline: image.tiff>>
The information contained in this message is confidential or protected by law.
If you are not the intended recipient, please contact the sender and delete this message. Any unauthorised copying of this message or unauthorised distribution of the information contained herein is prohibited.
