I guess I was trying to avoid getting notified for every alarm such as spikes, sags, packet loss, etc. and just wanted to focus on the lack of input power. I know, I know, I'm getting too picky now. I think I will set the notifier for alarms as you suggested and just see how it goes...
Don Goodhue Information Systems Officer Union Bank -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Christopher L. Sweeney Sent: Wednesday, September 19, 2007 9:25 AM To: InterMapper Discussion Subject: Re: [IM-Talk] APC UPS AP961x probe Notifier At 9:00 AM -0400 9/19/07, Don Goodhue wrote: >I use the APC AP961x probe on all our UPS units across the WAN. Is >there a way to have the probe trigger a notifier if the domestic power >is cut? >The probe monitors input voltage and battery life but I am looking for >something that will page me when the power goes out so we have time to >react before the UPS battery dies. > The probe will cause the device to go into the "Alarm" state when the UPS starts running on battery, so if you set a notifier for "Alarm", you should be notified when it switches to battery. -- Christopher -- ================================================ Christopher L. Sweeney Dartware, LLC http://www.dartware.com/ ____________________________________________________________________ List archives: http://www.mail-archive.com/intermapper-talk%40list.dartware.com/ To unsubscribe: send email to: [EMAIL PROTECTED] ____________________________________________________________________ List archives: http://www.mail-archive.com/intermapper-talk%40list.dartware.com/ To unsubscribe: send email to: [EMAIL PROTECTED]
