Andrew,
Cool probe!
--- You wrote:
I am attempting to write a custom SNMP probe for a RoomAlert24E. I have gotten
the probe to gather and display all of the data I need, but I cannot seem to set
up alarm/warning states based on it when i set the thresholds artificially low.
I believe that I am following the documentation correctly. The RoomAlert will
go in to an alarm state when it cannot be reached via SNMP.
I have added the code below. If anyone can tell me what I'm doing wrong, it would
be greatly appreciated.
--- end of quote ---
A quick skim doesn't show a problem. I'd like to get the contents of the Status
Window to see what's showing there.
Two Tips:
- In InterMapper 5.3, you can drag across the entire contents of the status window
and copy/paste
- In InterMapper 5.2 and earlier, you can right-click in the Status window and
Copy all...
It would also be useful to see the values entered for your parameters. You could
either enter them into the e-mail message, or add them (temporarily) to the <snmp-device-display>
section of the probe so they're shown as part of the status window.
Best regards,
Rich Brown [email protected]
Dartware, LLC http://www.intermapper.com
66-7 Benning Street Telephone: 603-643-9600
West Lebanon, NH 03784-3407 Fax: 603-643-2289
____________________________________________________________________
List archives:
http://www.mail-archive.com/intermapper-talk%40list.dartware.com/
To unsubscribe: send email to: [email protected]
