Hi All
Sorry for the newby questions, but I'm struggling to get my two IOIO
devices working fully. I have both an IOIO v1 & an IOIO-OTG. I can't
get the OTG to work at all, the v1 device works, but only using Bluetooth.
The Bluetooth dongle is a "BT2.0" (idVendor=0x0a12, idProduct=0x0001)
and one I just had lying around while I wait for the "Kinivo BTD-300"s
to arrive.
With the BT mode I can use the IOIO Hardware Tester to get a information
about the v1 card:
Hardware: SPRK0016
Bootloader: IOIO0311
Firmware: IOIO0400
I can also use the "IOIO Bluetooth Control Device" app from the play
store to control a seven segment display. So why won't the hardware
tester see the device when I plug it in to my Nexus 7? I do get a
pop-up titled "IOIO Standard Application" telling me that I don't have a
supported app installed. Is this a library issue?
With the OTG I get very little joy. It doesn't work with the BT dongle
or with the a physical connection, not even a popup.
If I plug the OTG into the PC I get the /dev/ttyACM0 device, so far so
good. Connecting a terminal program to it I see the following:
IOIOSPRK0020IOIO0400IOIO0330
Not sure how to interpret it, but I assume that it's reporting a later
hardware build and bootloader but the same firmware. I'm a correct?
Any advice to get these devices working using a physical connection?
Many thanks for your time
Steve
--
You received this message because you are subscribed to the Google Groups
"ioio-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/ioio-users.
For more options, visit https://groups.google.com/d/optout.
