Thank you! On 7 Apr 2014 18:41, "Ytai Ben-Tsvi" <[email protected]> wrote:
> You should measure resistance between out and GND (when the sensor is not > connected to anything) and turn the pot until you get about 5kOhm. Then you > can do everything we discussed previously in order to derive the actual gas > concentration. > > > On Mon, Apr 7, 2014 at 10:27 AM, Marius Vosylius < > [email protected]> wrote: > >> Ytai, I was able to use one of the Grove MQ2 Sensors below, but a thing >>> is that its only works without a resistor. Is this is ok? >>> >> >> <http://goog_254863602> >> http://seeedstudio.com/wiki/Twig_-_Gas_Sensor(MQ2) >> >> -- >> You received this message because you are subscribed to the Google Groups >> "ioio-users" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> To post to this group, send email to [email protected]. >> Visit this group at http://groups.google.com/group/ioio-users. >> For more options, visit https://groups.google.com/d/optout. >> > > -- > You received this message because you are subscribed to a topic in the > Google Groups "ioio-users" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/ioio-users/hwQrvPabwqc/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
