Most chances are that your board is OK. The best thing to do first is to connect the IOIO to a PC and make sure it enumerates correctly. Then run ioiodude --port=... versions to check which firmware versions you have on the board and verify that the board works in general. If it doesn't, put the IOIO into bootloader mode and repeat the test.
Once you have it working with the PC and we verify that you have the correct firmware on it, we can move on to fixing Android and Bluetooth. A few random comments on what the problem may be: - ADB mode does not work on late versions of Android. You should turn USB debugging off when using the IOIO over USB as a host. - Don't use "H" mode. "A" should be fine. - Make sure the trimmer on the IOIO is fully clockwise. - Please mention whether you're getting charging indication on the Android and/or the Accessory dialog when connecting the IOIO as a USB host. On Fri, Apr 25, 2014 at 1:55 PM, Gordon Martin <[email protected]>wrote: > I'm very frustrated at not having a responsive IOIO board. I received my > IOIO-OTG from Seeed Studio last week and just wanted to test it. > > I'm hoping this forum can help... > > I'm just trying to connect the IOIO to my Android device and use a test > app from the Play store to blink the yellow LED. > > I've tried many configurations: > > 1) Connected JST port to 12.5v power brick; connected to Android via red > OTG cable and micro USB. > 2) Connected JST port to 12.5v power brick; connected to Bluetooth dongle > via red OTG cable. > 3) Connected to Android host via a different OTG cable then micro into the > IOIO. > > I have an Android 4.2 tablet and Samsung 4.1 phone - both support OTG. I > have various bluetooth dongles - two of which match dongles I've seen used > in IOIO videos. I've enabled USB debug mode on my Android devices. The > IOIO switch is set to A but I've tried H. I've read as much documentation > as I can find. > > In all cases I get the bright red power LED but no other activity. The > bluetooth dongles never light up. My Android devices never connect to the > device or see a Bluetooth device. When I measure the power pins on the > IOIO I can verify that they provide the requisite 3.3 and 5 volts so I > expect the voltage regulator is functioning properly. > > What am I missing here? At this point I'm only left with thinking that > I've got a bad board, but that seems highly unlikely. > > Any help would be greatly appreciated. > > -- > You received this message because you are subscribed to the Google Groups > "ioio-users" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
