Is the question about using the IOIO while charging the Android? If so, this normally works. If it does not in your case, it is likely an issue specific to the Android devices you're using. Just to double-check: you should connect the IOIO so that it is in HOST mode, i.e. that the "A" side of the USB cable goes to the IOIO and the B side to the Android.
On Fri, Aug 29, 2014 at 10:00 AM, Aytaç Aral <[email protected]> wrote: > I try some way on asus memo pad hd and samsung note 2(N7100) > Standart OTG Cable, OTG-Y Cable or some resistor (40.2kohm, 69.1kohm, > 100kohm resistors for micro usb 4 and 5 pin) not work all. > Device only get OTG Mode or only get Charge mode. > how to booth enabled this ? > This is very important, I would be glad if you can help. > > Thanks... > > -- > You received this message because you are subscribed to the Google Groups > "ioio-users" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
