I also have intermittent connection issues--that is, intermittent ability to connect.
Even with the precompiled HelloIOIO program, I need to pause after cutting the power, before reapplying (same goes for the USB cable connection). If the disconnect/connect happens quickly, no connection is made. If I unplug again wait 2 seconds or more, then reconnect, it normally reconnects. When it fails to connect, I get the notifications of a USB accessory (multiple of them), but the GUI doesn't get enabled. I've also seen the case where plugging in gets reported as "Connected as a media device" in the notification bar--with no IOIO connection established. When in that state, it's repeatable until I power cycle the IOIO, making me think the firmware could be hung. I don't think this was the case when I used ADB moce. Ytai, do you not see this, when you unplug/replug quickly? On Thursday, January 15, 2015 at 9:54:06 AM UTC-5, Tim Frisch wrote: > > Tried out the V5.04 pre-compiled HelloIOIO Apk and it worked. I will work > my way down from there as you have said and if I figure it out or not I > will report back here. > > Thanks Ytai. > > On Thursday, January 15, 2015 at 8:02:55 AM UTC-6, Tim Frisch wrote: >> >> I had thought it would be that as well. However I have tried compiling a >> few of the apks you provide with no results. >> >> I also had already enabled project manifest merger and compared my >> manifest files which were identical in structure. > > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
