Hi, First of all, kudos to ioio and ytai, I really appreciate and love IOIO project.
My issue is that the moment I connect IOIO to the Android device, the power led on IOIO turns off. IOIO is still functioning properly when I connect it to the PC but does not get power when I connect it to the external power source. I've been studying this issue on the net (this very group) to figure out that it must be IOIO voltage regulator burn-out syndrome. I had a working setup - basically it is a remotely controlled tank (which I plan to present as soon as I get it working again) and I was stress testing it driving it around my room. Everything worked fine but my tank flipped several times after which it first started to experience random but frequent IOIO reconnects (increasingly frequent), culminating with definitive failure. In the aftermath of this stress test I figured out that: 1. IOIO power cables (connected to power JST on IOIO) were disconnected on the soldering point (due to physical damage when tank flipped I suppose). 2. IOIO couldn't be powered any more from the JST and neither VIN line but only from the PC when running in the device mode. After that I ordered another IOIO from the net, fixed my cables in the meantime, but as soon as I connected the new IOIO it's voltage regulator got burned - power led turned off and I couldn't get power any more unless I connected IOIO to the PC. Both mentioned IOIO's were IOIO OTG but not v2.2 with voltage regulation fix although my power cables are short (20cm) so I can not identify the issue as the one that was addresses through v2.2 fix. And this is what troubles me. I have now ordered two new IOIO's, one from Sparkfun and one from ebay but I am very afraid to connect them to my project before understanding what is causing the issue. It is worth mentioning that the USB cable I was using was custom made cable which I made from two USB cables, one OTG and one common which I've done because I wanted to have micro-USB to micro-USB OTG cable (which I can't find anywhere to purchase btw). But this cable was working properly - issue happened only after the tank flipped. I am now returning to original OTG cable but I'm still afraid not to burn any more IOIO's. I've tested the Andorid device USB port by connecting it to PC and it's both charging and enabling data transfer. Could it be that my custom cable went shortwired for a while and that caused the voltage regulator to burn? How would you proceed here? My debug plan is as following: 1. Connect the new IOIO to PC. 2. Connect IOIO to Android with original OTG cable + male USB to micro USB. 3. Connect JST power to IOIO. 4. Attach electronic circuit to IOIO. Is there anything else I can do in the debug process to prevent additional damage? -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
