On Wed, 2019-08-21 at 16:24 +0100, Will Deacon wrote:
> On Wed, Aug 21, 2019 at 09:53:12PM +0800, Yong Wu wrote:
> > MediaTek extend the arm v7s descriptor to support up to 34 bits PA where
> > the bit32 and bit33 are encoded in the bit9 and bit4 of the PTE
> > respectively. Meanwhile the iova still is 32bits.
> > 
> > Regarding whether the pagetable address could be over 4GB, the mt8183
> > support it while the previous mt8173 don't, thus keep it as is.
> > 
> > Signed-off-by: Yong Wu <[email protected]>
> > ---
> >  drivers/iommu/io-pgtable-arm-v7s.c | 32 +++++++++++++++++++++++++-------
> >  include/linux/io-pgtable.h         |  7 +++----
> >  2 files changed, 28 insertions(+), 11 deletions(-)
> 
> [...]
> 
> > @@ -731,7 +747,9 @@ static struct io_pgtable *arm_v7s_alloc_pgtable(struct 
> > io_pgtable_cfg *cfg,
> >  {
> >     struct arm_v7s_io_pgtable *data;
> >  
> > -   if (cfg->ias > ARM_V7S_ADDR_BITS || cfg->oas > ARM_V7S_ADDR_BITS)
> > +   if (cfg->ias > ARM_V7S_ADDR_BITS ||
> > +       (cfg->oas > ARM_V7S_ADDR_BITS &&
> > +        !(cfg->quirks & IO_PGTABLE_QUIRK_ARM_MTK_EXT)))
> 
> Please can you instead change arm_v7s_alloc_pgtable() so that it allows an
> ias of up to 34 when the IO_PGTABLE_QUIRK_ARM_MTK_EXT is set?

Here I only simply skip the oas checking for our case. then which way do
your prefer?  something like you commented before:?


        if (cfg->ias > ARM_V7S_ADDR_BITS)
                return NULL;

        if (cfg->quirks & IO_PGTABLE_QUIRK_ARM_MTK_EXT) {
                if (!IS_ENABLED(CONFIG_PHYS_ADDR_T_64BIT))
                        cfg->oas = min(cfg->oas, ARM_V7S_ADDR_BITS);
                else if (cfg->oas > 34)
                        return NULL;
        } else if (cfg->oas > ARM_V7S_ADDR_BITS) {
                return NULL;
        }


> 
> With that change:
> 
> Acked-by: Will Deacon <[email protected]>
> 
> Will
> 
> _______________________________________________
> Linux-mediatek mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-mediatek


Reply via email to