On Sat, Oct 17, 2020 at 04:25:25AM -0700, Raj, Ashok wrote: > > For devices that *don't* use a stop marker, the PCIe spec says (10.4.1.2): > > > > To stop [using a PASID] without using a Stop Marker Message, the > > function shall: > > 1. Stop queueing new Page Request Messages for this PASID. > > The device driver would need to tell stop sending any new PR's. > > > 2. Finish transmitting any multi-page Page Request Messages for this > > PASID (i.e. send the Page Request Message with the L bit Set). > > 3. Wait for PRG Response Messages associated any outstanding Page > > Request Messages for the PASID. > > > > So they have to flush their PR themselves. And since the device driver > > completes this sequence before calling unbind(), then there shouldn't be > > any oustanding PR for the PASID, and unbind() doesn't need to flush, > > right? > > I can see how the device can complete #2,3 above. But the device driver > isn't the one managing page-responses right. So in order for the device to > know the above sequence is complete, it would need to get some assist from > IOMMU driver?
No the device driver just waits for the device to indicate that it has completed the sequence. That's what the magic stop-PASID mechanism described by PCIe does. In 6.20.1 "Managing PASID TLP Prefix Usage" it says: "A Function must have a mechanism to request that it gracefully stop using a specific PASID. This mechanism is device specific but must satisfy the following rules: [...] * When the stop request mechanism indicates completion, the Function has: [...] * Complied with additional rules described in Address Translation Services (Chapter 10 [10.4.1.2 quoted above]) if Address Translations or Page Requests were issued on the behalf of this PASID." So after the device driver initiates this mechanism in the device, the device must be able to indicate completion of the mechanism, which includes completing all in-flight Page Requests. At that point the device driver can call unbind() knowing there is no pending PR for this PASID. Thanks, Jean > > How does the driver know that everything host received has been responded > back to device? > > > > > > I'm not sure about other IOMMU's how they behave, When there is no space > > > in > > > the PRQ, IOMMU auto-responds to the device. This puts the device in a > > > while (1) loop. The fake successful response will let the device do a ATS > > > lookup, and that would fail forcing the device to do another PRQ. > > > > But in the sequence above, step 1 should ensure that the device will not > > send another PR for any successful response coming back at step 3. > > True, but there could be some page-request in flight on its way to the > IOMMU. By draining and getting that round trip back to IOMMU we gaurantee > things in flight are flushed to PRQ after that Drain completes. > > > > So I agree with the below if we suspect there could be pending PR, but > > given that pending PR are a stop marker thing and we don't know any device > > using stop markers, I wondered why I bothered implementing PRIq flush at > > all for SMMUv3, hence this RFC. > > > > Cheers, > Ashok _______________________________________________ iommu mailing list firstname.lastname@example.org https://lists.linuxfoundation.org/mailman/listinfo/iommu