> On Tue, Apr 30, 2002 at 09:04:20PM +0200, Karol Daniszewski wrote: > > ...but tcpdump doesn't show anything with (source or not) address > > 195.205.159.14 on the fxp1 interface. Even when I'm sending icmp echo > > requests from the outside to this IP tcpdump shows incoming requests but > > there are no reply on the both interfaces fxp0 and fxp1. The fxp1 is dead. > > Still confused I'm asking for any advices. > > IIRC, ipnat(8) does its magic on the packets _after_ they've gone > through the bpf(4) device. That is, the packets get NAT'ed _after_ > tcpdump(8) sees them on the way out. > -- > Crist J. Clark | [EMAIL PROTECTED]
So I put another machine with ip address 195.205.159.15 and put all the cables between these two hosts and router to the hub. When I'm doing 'ping -S 195.205.159.14 'in the machine with ipf to _any_ host on the other machine I see something like that: 10:25:16.696050 195.205.159.14 > 195.205.159.2: icmp: echo request 10:25:16.697524 195.205.159.2 > 195.205.159.14: icmp: echo reply and the icmp echo reply times are all the same and so small about 1ms. I say again: ping times to any host are the same and they are similar to ping times to the router. Now that is not normal for sure. And why on the other machine i can't see anything else but icmp to the router (195.205.159.2) ? I think that's way the 'traceroute -s 195.205.159.14' behavior was so strange because the ipf is changing all the destination ip addresses. Maybe someone can explain that ? -- Karol Daniszewski http://net.art.pl/ Net Art
