Hi Eric, The installation you chose is for Solaris 2.x versions, so all prior to version 7, as you can see from your uname output, you run Solaris 5.8, which is 8 in fact, most installation/build files are called "Solaris", not "sol2", this indicates older builds of Solaris.
For Solaris 8, you can get pre-built versions on www.sunfreeware.com, choose "Solaris 8" on top right frame, or you go to http://anders.fix.no/solaris/pkg/sol8/sparc32-64/ , where you find more pre-builds for Solaris 8, including the current IPFilter version in 32/64 bit, I used this one, and it runs perfect for me, including NAT. You may read through your "INSTALL.Sol2" and "INSTALL.solaris" files to find more details about the differences. Cheers, Frank -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Eric A. Sauer Sent: Saturday, May 04, 2002 11:38 PM To: [EMAIL PROTECTED] Subject: Solaris 8 with no IPnat [Hello: I am running, as indicated below, Solaris 8 on an Ultra 5 machine and I am attempting to use IP Filter 3.4.25. I followed the directions for installation per the file "INSTALL.Sol2" and the installation appeared to go smoothly (ipf.conf appears to be working); however, I did not get /dev/ipnat and as one can imagine am unable to run ipnat. Per the FAQ directions, I am including the designated commands and their output. Sun Microsystems Inc. SunOS 5.8 Generic February 2000 # uname -a SunOS unknown 5.8 Generic_108528-13 sun4u sparc SUNW,Ultra-5_10 # isainfo -vk 32-bit sparc kernel modules # ifconfig -a lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1 inet 127.0.0.1 netmask ff000000 hme0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2 inet 12.253.225.130 netmask fffffc00 broadcast 12.253.227.255 ether 8:0:20:b9:38:5d # netstat -rn Routing Table: IPv4 Destination Gateway Flags Ref Use Interface -------------------- -------------------- ----- ----- ------ --------- 12.253.224.0 12.253.225.130 U 1 3 hme0 default 12.253.224.1 UG 1 23 127.0.0.1 127.0.0.1 UH 22 6454 lo0 # netstat -i Name Mtu Net/Dest Address Ipkts Ierrs Opkts Oerrs Collis Queue lo0 8232 loopback localhost 6482 0 6482 0 0 0 hme0 1500 dhcp-87-4618 dhcp-87-4618 4803 0 796 0 20 0 # netstat -s -P ip IPv4 ipForwarding = 2 ipDefaultTTL = 255 ipInReceives = 828 ipInHdrErrors = 0 ipInAddrErrors = 0 ipInCksumErrs = 0 ipForwDatagrams = 0 ipForwProhibits = 0 ipInUnknownProtos = 0 ipInDiscards = 0 ipInDelivers = 7360 ipOutRequests = 791 ipOutDiscards = 0 ipOutNoRoutes = 0 ipReasmTimeout = 60 ipReasmReqds = 0 ipReasmOKs = 0 ipReasmFails = 0 ipReasmDuplicates = 0 ipReasmPartDups = 0 ipFragOKs = 0 ipFragFails = 0 ipFragCreates = 0 ipRoutingDiscards = 0 tcpInErrs = 0 udpNoPorts = 0 udpInCksumErrs = 0 udpInOverflows = 0 rawipInOverflows = 0 ipsecInSucceeded = 0 ipsecInFailed = 0 ipInIPv6 = 0 ipOutIPv6 = 0 ipOutSwitchIPv6 = 1 # ipf -V ipf: IP Filter: v3.4.25 (432) Kernel: IP Filter: v3.4.25 Running: yes Log Flags: 0 = none set Default: pass all, Logging: available Active list: 1 # ipfstat dropped packets: in 0 out 0 non-data packets: in 5 out 5 no-data packets: in 0 out 0 non-ip packets: in 0 out 0 bad packets: in 0 out 0 copied messages: in 0 out 126 IPv6 packets: in 0 out 0 input packets: blocked 66 passed 828 nomatch 0 counted 0 short 0 output packets: blocked 0 passed 791 nomatch 0 counted 0 short 0 input packets logged: blocked 4 passed 0 output packets logged: blocked 0 passed 0 packets logged: input 0 output 0 log failures: input 0 output 0 fragment state(in): kept 0 lost 0 fragment state(out): kept 0 lost 0 packet state(in): kept 0 lost 0 packet state(out): kept 133 lost 0 ICMP replies: 0 TCP RSTs sent: 0 Invalid source(in): 0 Result cache hits(in): 60 (out): 0 IN Pullups succeeded: 0 failed: 0 OUT Pullups succeeded: 0 failed: 0 Fastroute successes: 0 failures: 0 TCP cksum fails(in): 0 (out): 0 Packet log flags set: (0) none # ipfstat -io pass out quick on hme0 proto tcp from 12.253.225.130/32 to any keep state pass out quick on hme0 proto udp from 12.253.225.130/32 to any keep state pass out quick on hme0 proto icmp from 12.253.225.130/32 to any keep state block in quick on hme0 from any to 255.255.255.255/32 pass in quick on hme0 from 12.253.227.119/32 to any block return-rst in log proto tcp from any to 12.253.225.130/32 block return-icmp-as-dest(port-unr) in log on hme0 proto udp from any to 12.253.225.130/32 block in log quick on hme0 from any to any # ipnat -slv /dev/ipnat: open: No such file or directory Please advise. Thank you. Eric Sauer]
