David Stes wrote:
I'm not sure this is the proper solution, but the way I think you're
supposed to compile the proxies is by modifying
ip_proxy.c
and by moving
#include "ip_rcmd_pxy.c"
a few lines higher, above
/* END OF INCLUDES */
because the Makefile's scan for that comment and generate sources based on it.
On Thu, Aug 21, 2008 at 03:36:29PM -0400, Steve Clark wrote:
Hi,
I have gotten 4.1.31 to compile an run on centos 5.2 linux kernel
2.6.18-92.1.10.el5.
It seems to be mostly working ok after some minor changes for locking. I have just discovered a
problem with ipnat though trying to setup a ftp proxy rule.
map eth1 192.168.4.0/24 -> 2.2.2.1/32 proxy port ftp ftp/tcp
when I try to insert this I get:
[EMAIL PROTECTED] proc]# ipnat -CF -f /etc/ipnat.cfg
0 entries flushed from NAT table
0 entries flushed from NAT list
1:ioctl(add/insert nat rule): No such file or directory
other map rules seem to be ok.
Could someone point me where I should start looking for this problem. I haven't
been able to
figure out how ip_ftp_pxy.c get compiled and where it ends up. I can't find a
.o file in the
Linux/Linux-2.6.18-92.1.10.el5-i686 directory.
Thanks,
Steve
Hi David,
I put
#error "in ip_ftp_proxy"
in the ip_ftp_pxy.c file to see if it was being included and as you can see
below it appears
that it is being included into ip_proxy.c - so there must be something else
going wrong.
make[1]: Entering directory `/root/ip_fil4.1.31/Linux'
cc -I. -ILinux-2.6.18-92.1.10.el5-i686 -g -I.. -D_BSD_SOURCE
-DIPFILTER_LOOKUP -DIPFILTER_SCAN -DIPFILTER_LOG -DLINUX=20618 -c ../ip_proxy.c
-o Linux-2.6.18-92.1.10.el5-i686/ip_proxy_u.o
In file included from ../ip_proxy.c:91:
../netinet/ip_ftp_pxy.c:11:2: error: #error "in ip_ftp_proxy"
make[1]: *** [Linux-2.6.18-92.1.10.el5-i686/ip_proxy_u.o] Error 1
Thanks,
Steve
