When bringing up an IPMI session, there are portions of it in the begging that are done with auth NONE until a user is authenticated and the session fully established. You are likely looking at the packets that are early in the process.
Al On Wed, 2017-02-22 at 14:27 -0800, VJ wrote: > I followed the instruction > from : > https://www.thomas-krenn.com/en/wiki/Deactivate_IPMI_NONE_Authentication_Type > > > and I can see the below from 'ipmitool lan print 1' > Admin : MD5 > > > > But, when I try to access from ipmitool, > > > I see : > BUILDING A v1.5 COMMAND > >> IPMI Request Session Header > >> Authtype : NONE > > > whats happening ? > > > Thanks. > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ Ipmitool-devel mailing list > Ipmitool-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/ipmitool-devel -- Albert Chu ch...@llnl.gov Computer Scientist High Performance Systems Division Lawrence Livermore National Laboratory ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Ipmitool-devel mailing list Ipmitool-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/ipmitool-devel
