Hi, I use WinPE to install Windows 10 RS4 on an iSCSI target in OpenStack. The installation went well. However, after the installation the Windows will reboot itself to complete the rest of the installation. That's where the problem starts. I get the following error messages during boot up "Recovery Your PC/Device needs to be repaired The operating system couldn't be booted because the digital signature of a file couldn't be verified File: \Windows\System32\drivers\e1i65x64.sys Error code 0xc0000428 " I have to go the advanced boot menu to disable driver signature check then it can boot successfully. Once it is booted I checked the detail of the network driver, it is actually using e1i63x64.sys not e1i65x64.sys The hardware ids of the driver are PCI\VEN_8086&DEV_15B8&SUBSYS_86721643&REV_00 PCI\VEN_8086&DEV_15B8&SUBSYS_86721643 PCI\VEN_8086&DEV_15B8&CC_02000 PCI\VEN_8086&DEV_15B8&CC_0200
If I install Windows 10 RS4 on a local hard disk. There is no problem. The problem only shows up when I try to install on an iSCSI target. I tried to use the following bcdedit commands to permanently disable the driver signature checks and nothing works. I have to manually hit the F7 key to disable the driver check on EVERY reboot bcdedit /set testsigning on bcdedit /set nointegritychecks on bcdedit /set loadoptions DIABLE_INTEGRITY_CHECKS Desperately need your help to solve this problem Thanks in advance Qing ----------------------------------------------------------------------------------- This email message is for the sole use of the intended recipient(s) and may contain confidential information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message. -----------------------------------------------------------------------------------
_______________________________________________ ipxe-devel mailing list [email protected] https://lists.ipxe.org/mailman/listinfo.cgi/ipxe-devel
